Equipment

Roller Dyno

Roller Dyno is a diagnostic tool specifically designed to measure the power of a lot of type of vehicles.
This one consists of four rollers, two each sides, to perform test for front and rear driven vehicles.
All dynos work to mimic load conditions by exerting brake forces on a motor. In roller dyno , one of the vehicle’s axis rests on a roller that is used to measure the output power delivered to the wheels as horsepower and speed. This is convenient for automotive testing because the vehicle can be set on the machine without removing the engine.

HIL(hardware in loop) engine Simulator

Simulates the engine in HIL(hardware in loop) mode. An HIL simulation include electrical emulation of sensors and actuators. These electrical emulators act as the interface between the bench simulator and the embedded system under test. The value of each electrically emulated sensor is controlled by the bench simulator and is read by the embedded system under test . Likewise, the ECU under test implements its control algorithms by outputting actuator control signals. Changes in the control signals result in changes to variable values in the bench simulator

Other Equipment

  • ECU test bench
  • R&D wirings
  • Diagnostics testers

    CF3000 srl was founded in 1999 as R&D of advanced electronics. Active in particular in the automotive sector, it has become a reference for the development and design of solutions for on-board vehicle electronic collaborating with some of the world’s leading manufacturers.

    CF3000 Engineering

    Via Tonino Gualtieri,1 – 42123 Reggio Emilia

    CF3000 Automotive Electronics

    Via Yuri Gagarin, 31 – 42123 Reggio Emilia

    CF3000 Engineering India

    411, DLF Tower B, Jasola District Centre – 110076 New Delhi – India

    PHONE

    +39 0522 361134

    EMAIL

    info@cf3000.it